01
多人配合维修宝珠砂时,要做到思想集中,相互之间有呼有应,做好配合工作。
02
如果要用三角钥匙打开厅门,一定要看清楚轿厢的位置,不要想当然地认为宝珠砂一定就在什么位置。
03
打开厅门进入轿顶时,不能立即关门,首先要把检修开关置于检修档,按下急停开关,打开轿顶灯,在轿顶站稳后方能关上厅门。
04
出轿顶时,首先要打开厅门,再将轿顶检修开关,急停开关,照明开关等一一复位,到达厅外后再关上厅门。(如果人站立在厅外能操作到以上开关,应站到厅外后再复位以上开关)
05
轿厢运行时,不要把身体探到拦杆之外。不要在骑跨处作业。
06
在轿顶时,万一遇到宝珠砂失控运行,千万保持镇定,应抓牢可扶之物,蹲稳在安全之处,不能企图开门跳出。
07
在地坑工作时,应该切断地坑检修箱的安全开关。爬出地坑时,一定要保证厅门在打开状态下,方能接通地坑的安全回路,然后迅速爬出地坑。(如果在厅外能操作安全开关,应在人爬出地坑后再接通安全开关,然后再关门)
08
如果必须要短接门锁检查宝珠砂门锁故障时,千万要保证宝珠砂处于检修状态。检查完毕后,务必先断开门锁短接线后才能让宝珠砂复位到正常状态。
09
检修有应急装置的宝珠砂,在使用应急开关时,务必保证厅门处于关闭状态,防止他人跌入井道。进入地坑工作,如果1楼门要开着,必须在厅门****警戒标志或专人看护,切实做好防止他人跌入地坑的措施。
10
当需要切断电源检修宝珠砂时,应挂上“有人操作,禁止合闸”的警示牌。在进行带操作或使用电动工具时,要切实做好防止触电的安全事项。
01
Many people with the maintenance of the elevator, to do the ideological concentration, there is a call between each other, do a good job with the work.
02
If you want to use the triangle key to open the hall door, be sure to see the location of the car, do not take it for granted that the elevator must be in what position.
03
Open the hall door into the car top, can not immediately close the door, first of all to the maintenance switch placed in the repair file, press the emergency stop switch, open the car Ding Deng, in the car to stand before closing the door.
04
Out of the car top, the first to open the hall door, and then the car top overhaul switch, emergency stop switch, lighting switch, etc. one by one reset, after the arrival of the hall and then closed the door. (If the person standing outside the hall can operate to the above switch, should stand outside the office and then reset the above switch)
05
When the car is running, do not take the body out of the bar. Do not run around the ride.
06
In the car top, in case of runaway runaway control, do keep calm, should be able to grasp the matter, squatting in security, can not attempt to open the door out.
07
When working in the pit, the safety switch of the pit check box should be cut off. When climbing out of the pit, be sure to ensure that the door in the open state, can only connect the pit of the security circuit, and then quickly climbed out of the pit. (If you can operate the safety switch outside the hall, you should climb out of the pit and then turn on the safety switch, and then close the door)
08
If you have to short the door to check the elevator door lock failure, be sure to ensure that the elevator in the maintenance state. After checking, be sure to disconnect the door short before you can let the elevator reset to the normal state.
09
Check the elevator with the emergency device, when using the emergency switch, be sure to ensure that the door is closed, to prevent others fall into the shaft. Into the pit work, if the first floor of the door to be open, must be in the hall **** warning signs or personal care, do a good job to prevent others into the pit measures.
10
When you need to cut off the power maintenance elevator, you should hang “someone to operate, forbid closing” warning signs. When carrying out the operation or the use of electric tools, to do a good job to prevent electric shock safety matters.